Electronics


Electronics->> POWER SUPPLY CIRCUITS

Most electronic equipment requires DC voltages for its operation. These can be provided by batteries (see Battery) or by internal power supplies that convert alternating current as available at the home electric outlet, into regulated DC voltages. The first element in an internal DC power supply is a transformer, which steps up or steps down the input voltage to a level suitable for the operation of the equipment. A secondary function of the transformer is to provide electrical ground insulation of the device from the power line to reduce potential shock hazards. The transformer is then followed by a rectifier, normally a diode. In the past, vacuum diodes and a wide variety of different materials such as germanium crystals or cadmium sulfide were employed in the low-power rectifiers used in electronic equipment. Today silicon rectifiers are used almost exclusively because of their low cost and their high reliability.

Fluctuations and ripples superimposed on the rectified DC voltage (noticeable as a hum in a malfunctioning audio amplifier) can be filtered out by a capacitor; the larger the capacitor, the smaller is the amount of ripple in the voltage. More precise control over voltage levels and ripples can be achieved by a voltage regulator, which also makes the internal voltages independent of fluctuations that may be encountered at an outlet. A simple, often-used voltage regulator is the zener diode. It consists of a solid-state p-n-junction diode, which acts as an insulator up to a predetermined voltage; above that voltage it becomes a conductor that bypasses excess voltages. More sophisticated voltage regulators are usually constructed as integrated circuits.

Comments

Popular posts from this blog

Hanaoka Seishu

Modern Agriculture

Brahe, Tycho